HEIDENHAIN IK 5294 - Manual (Page 321)

File Formats
Appendix
A
File formats
The lines of the file beginning with T define the diameter of holes for each of the holes that following the
T line, until the next T is encountered. The number immediately after the T refers to a hole size identifier
in the TOL file. If there is no TOL file, or if the identifier cannot be found, the user is prompted to enter
in the hole diameter.
The TOL file defines hole sizes and uniquely identifies them. The format is:
---------------------------------------------------------------------------
---------------------------------------------------------------------------
---------------------------------------------------------------------------
T1 00030
T2 01234
T3 00123
…
The 3 dashed lines are ignored.
The number immediately after the T is an identifier (label) for a hole size. The number immediately after
the T identifier is the hole size, in metric units.
Appendix A OE.indd 3 5/9/2005 10:09:15 AM