HEIDENHAIN IK 5294 - Manual (Page 268)

248 QC5200 Series User’s Guide
Specifying error messages
Error messages can be displayed that describe most
system errors. These messages are specified in the
Errors screen and listed below.
All errors are enabled for display by default. Any
of these error messages can be disabled by clear-
ing their check boxes. All error messages can be
disabled simultaneously by checking the Disable
all system error messages box.
CAUTION
Disabling error messages can
hide error conditions that pro-
duce faulty measurement data.
Do not disable error messages
unless you fully understand the
consequences.
Click the Tools/Customize/Errors menu item to display the Errors screen.
NOTE
The error messages are not necessarily listed here in their order of appearance in the
Error screen list box.
System error messages
• Temperature Compensation should be disabled before doing any kind of Teach or Calibration.
• NC control off.
• A Device Driver is either not installed on your PC, or is not working properly. Because of this, the
Axis Cards will not work.
• An Axis Card is either not installed on your PC, or is not working properly. Because of this the
DRO will not work, and measurements can only be probed using the Demo Stage
(located under the Windows menu).
• A scale error has occurred on your X axis.
• A scale error has occurred on your Y axis.
• A scale error has occurred on your Z axis.
• A scale error has occurred on your Q axis.
• A hardware error has occurred while trying to read your Axis Card.
10 Supervisor setup OE.indd 8 5/9/2005 10:03:45 AM