HEIDENHAIN IK 5294 - Manual (Page 214)

194 QC5200 Series User’s Guide
Creating Programs
The basic programming process shown here is identical for all part types. The details of individual steps
are described in the remaining pages of this section.
A measurement program
is created by recording
the user’s activities
Features are imported and
a measurement program
is created by the system
Tolerances are specified for features
Measurement results are printed or exported
The measurement path is reduced to
increase throughput
Comments, delays, sounds, images, user
messages are added to the program
Feature display modes and point filtering are
specified
Part fixturing, general program setup and
pallet setup are specified
No further user activities are recorded
A new file space is reserved for feature data
and program steps
All subsequent programmable user activities
will be recorded as a part program
A measurement reference is created for the
part
Feature data and program steps are saved
8 Programming OE.indd 4 5/9/2005 9:55:01 AM