HEIDENHAIN IK 5294 - Manual (Page 145)

5
Measuring
125
Lines constructed from two lines
Select the desired line features, click Measure Line and then click OK. The
new line feature will be constructed bisecting the angle between the two par-
ent lines, and will be shown in the Features template, Part View window and
Results window. Right-click the Results window to show alternative line
features. When the Gage line alternative is selected, you will be prompted for
the gage line length.
Line constructed from a line and a distance
An offset line can be constructed from line and distance parent features. Se-
lect the desired line and distance features, click Measure Line and then click
OK. The line will be constructed, offset the amount equal to the distance
parent and will be shown in the Features template, Part View window and
Results window.
Right-click the Results
window to display an
alternative feature
Bisector line 2
User prompt for gage line length
Gage line length
Constructing Features
5 Measuring OE.indd 43 5/9/2005 10:00:44 AM