HEIDENHAIN iTNC 530 (340 49x-03) smarT.NC Pilot User Manual
Page 95

95
D
e
fining Machining O
p
erations
Unit 130 Contour Pocket on Point Pattern (FCL 3 Function)
With this working unit you can align on any pattern and rough out
pockets, which may contain islands, of any shape.
If necessary, you can assign every subcontour its own depth (FCL 2
function) in the contour detail form. In this case you must always begin
with the deepest pocket.
Parameters on the overview form:
8
T:
Tool number or name (switchable via soft key)
8
S:
Spindle speed [rpm] or cutting speed [m/min or ipm]
8
F:
Feed rate for reciprocating plunge [mm/min], FU [mm/rev] or FZ
[mm/tooth] Enter 0 for perpendicular infeed
8
F:
Feed rate for plunging [mm/min], FU [mm/rev] or FZ [mm/tooth]
8
F:
Feed rate for plunging [mm/min] or FU [mm/rev] or FZ [mm/tooth]
8
Depth:
Milling depth.
8
Plunging depth:
Infeed per cut.
8
Allowance for side:
Finishing allowance for the side.
8
Allowance in depth:
Finishing allowance for the depth.
8
Contour name:
List of the subcontours (.HC files) to be linked. If the
DXF converter option is available, you can use it to make a contour
directly from the form.