HEIDENHAIN iTNC 530 (340 49x-03) smarT.NC Pilot - Manual (Page 57)

57
D
e
fining Machining O
p
erations
Unit 206 Tapping with a Floating Tap Holder
Parameters on the overview form:
8 T: Tool number or name (switchable via soft key)
8 S: Spindle speed [rpm] or cutting speed [m/min or ipm]
8 F: Drilling feed rate: Calculate from S multiplied by thread pitch p
8 Depth of thread: Depth of the thread.
8 Machining positions (see “Defining Machining Positions” on page
121.)
Additional parameters on the tool detail form:
8 DL: Delta length for tool T.
8 M function: Any miscellaneous function M.
8 Spindle: Direction of spindle rotation. As a default, smarT.NC sets M3.
8 Tool preselect: If needed, this is the number of the next tool for faster
tool change (machine-dependent).
Additional parameters on the drilling parameters detail form:
8 None
Globally effective parameters on the global data detail form:
8 Set-up clearance
8 2nd set-up clearance
8 Dwell time at depth
8 Feed rate for traversing between machining positions