HEIDENHAIN iTNC 530 (340 49x-03) smarT.NC Pilot - Manual (Page 156)

156
P
roce
ssing
DXF
Files
(Sof
tware
Op
ti
on
)
8 If necessary you can also deselect elements that you
already selected, by clicking the element in the right window
again, but this time while pressing the CTRL key.
8 To save the selected contour elements in a plain-language
program, enter any file name in the pop-up window
displayed by the TNC. Default setting: Name of the DXF file
8 Confirm the entry: The TNC saves the contour program in
the directory in which the DXF file is also saved.
8 If you want to select more contours, press the CANCEL
SELECTED ELEMENTS soft key and select the next contour
as described above.
The TNC also transfers the workpiece-blank definition
(BLK FORM)
to the contour program.
The TNC only saves elements that have actually been
selected (blue elements).
If you call the DXF converter from a form, smarT.NC
automatically closes the DXF converter after you have
completed the SAVE SELECTED ELEMENTS function.
Then smarT.NC writes the defined contour names to the
input field from which you have started the DXF
converter.