beautypg.com

HEIDENHAIN iTNC 530 (340 49x-03) smarT.NC Pilot User Manual

Page 90

background image

90

D

e

fining Machining O

p

erations

Unit 124 Contour Pocket Side Finishing

With the side finishing unit you can finish the side of a contour pocket
that has been roughed-out with unit 122.

Parameters on the overview form:

8

T:

Tool number or name (switchable via soft key)

8

S:

Spindle speed [rpm] or cutting speed [m/min or ipm]

8

F:

Feed rate for plunging [mm/min], FU [mm/rev] or FZ [mm/tooth]

8

F:

Feed rate for plunging [mm/min] or FU [mm/rev] or FZ [mm/tooth]

8

Plunging depth:

Infeed per cut.

Additional parameters on the tool detail form:

8

DL:

Delta length for tool T.

8

DR:

Delta radius for tool T.

8

DR2:

Delta radius 2 (corner radius) for tool T.

8

M function:

Any miscellaneous function M.

8

Spindle:

Direction of spindle rotation. As a default, smarT.NC sets M3.

8

Tool preselect:

If needed, this is the number of the next tool for faster

tool change (machine-dependent).

Always run the side finishing operation after floor finishing!