HEIDENHAIN iTNC 530 (340 49x-03) smarT.NC Pilot - Manual (Page 93)

93
D
e
fining Machining O
p
erations
8 Center angle (Only in effect if tangential approach on a circular path
was selected): Angle of the circular arc.
8 Distance to aux. point (Only in effect if tangential approach on a
straight path or vertical approach was selected): Distance to the
auxiliary point from which the contour is approached.
8 Contour name: Name of the contour file (.HC) to be machined. If the
DXF converter option is available, you can use it to make a contour
directly from the form.