beautypg.com

HEIDENHAIN iTNC 530 (340 49x-03) smarT.NC Pilot User Manual

Page 123

background image

123

Defining

Mach

ining

Posit

io

ns

Starting the pattern generator from a form

8

Select the smarT.NC operating mode.

8

Select any machining step in which machining positions can
be defined.

8

Select an input field in which a machining position is to be
defined (see figure at top right).

8

Switch to Define machining positions in point table.

8

To create a new file: Enter the file name (without the file
type), and confirm with the NEW .HP soft key.

8

Specify the units of measurement for the new point file with
the MM or INCH button in the pop-up window. smarT.NC
then starts the pattern generator.

8

To select an existing HP file: Press the SELECT .HP soft
key. smarT.NC opens a pop-up window with available point
files. Select one of the displayed files, and open it with the
ENT key or OK screen button.

8

To edit an existing HP file: Press the EDIT .HP soft key.
smarT.NC starts the pattern generator.

8

To select an existing PNT file: Press the SELECT .PNT soft
key. smarT.NC opens a pop-up window with available point
files. Select one of the displayed files, and open it with the
ENT key or OK screen button.

If you want to edit a .PNT file, smarT.NC converts it to an .HP
file! Answer the dialog prompt with OK.