HEIDENHAIN iTNC 530 (340 49x-03) smarT.NC Pilot - Manual (Page 115)

115
D
e
fining Machining O
p
erations
The following plane definitions are available:
You can use soft keys to switch the positioning behavior, the selection of
the tilt direction and the type of transformation.
Type of plane definition Soft key
Plane defined by spatial angle
Plane defined by projection angle
Plane defined by Euler angle
Plane defined by vector
Plane defined by three points
Define an incremental spatial angle
Define axis angles (FCL 3 function)
Reset the tilted plane function
The type of transformation is effective only in
transformations with a C axis (rotary table).