beautypg.com

Running a unit program – HEIDENHAIN iTNC 530 (340 49x-03) smarT.NC Pilot User Manual

Page 166

background image

166

G

raphically Testing and

Running a Unit Program

Running a unit program

You can run a unit program in the Execute submode in the following
ways:

„

Run the unit program unit by unit

„

Run the entire unit program

„

Run individual, active units

You can run UNIT programs (*.HU) in the smarT.NC
operating mode, or in the usual Program Run, Single Block or
Program Run, Full Sequence operating modes.

When the smarT.NC Program Run operating mode is
selected, the TNC automatically deactivates all global
program-run settings that you have activated in the
conventional Single Block and Full Sequence program run
modes. Refer to the Conversational User’s Manual for more
information about this.

Please note the instructions on running programs in the
machine manual and the user’s manual.