HEIDENHAIN iTNC 530 (340 49x-03) smarT.NC Pilot - Manual (Page 35)

35
D
e
fining Machining O
p
erations
Program settings
After you have created a new unit program, smarT.NC automatically
inserts the Unit 700 Program Settings.
The following data must be defined in the program settings:
„ Workpiece blank definition for determining the machining plane and for
the graphic simulation
„
Options for selection of the workpiece preset and the datum table to
be used.
„ Global data, valid for the entire program. The global data are
automatically assigned default values by smarT.NC. These can be
changed at any time.
The Unit 700 Program Settings must exist in a program,
otherwise that program cannot be executed by smarT.NC.
Please note that later changes to the program settings affect
the entire machining program, and can therefore change the
machining procedure significantly.