HEIDENHAIN TNC 128 (77184x-01) - Manual (Page 66)

66 Introduction
2.4 St
at
us disp
la
ys
Program section repeat/Subprograms (LBL tab)
Information on standard cycles (CYC tab)
Soft key Meaning
No direct
selection
possible Active program section repeats with block
number, label number, and number of
programmed repeats/repeats yet to be run
Active subprogram numbers with block number in
which the subprogram was called and the label
number that was called
Soft key Meaning
No direct
selection
possible Active machining cycle