HEIDENHAIN TNC 128 (77184x-01) - Manual (Page 382)

382 Fundamentals of cycles
15.7 P
o
int tables
Hiding single points from the machining process
In the FADE column of the point table you can specify if the defined
point is to be hidden during the machining process.
In the table, select the point to be hidden
Select the FADE column
Activate hiding, or
Deactivate hiding
Selecting a point table in the program
In the Programming and Editing mode of operation, select the
program for which you want to activate the point table:
Press the PGM CALL key to call the function for
selecting the point table
Press the POINT TABLE soft key
Enter the name of the point table and confirm your entry with the END
key. If the point table is not stored in the same directory as the NC
program, you must enter the complete path
Example NC block
7 SEL PATTERN "TNC:\DIRKT5\NUST35.PNT"