HEIDENHAIN TNC 128 (77184x-01) - Manual (Page 52)

52 First steps with the TNC 128
1
.6 W
o
rk
piece set
u
p 1.6 Workpiece setup
Selecting the correct operating mode
Workpieces are set up in the Manual Operation or El. Handwheel
mode
 Press the Manual Operation operating mode key: the
TNC switches to that mode
Further information on this topic
 Manual Operation mode: See "Moving the machine axes" on page
278
Clamp the workpiece
Mount the workpiece with a fixture on the machine table so that it is
fixed with its edges parallel to the machine axes.