HEIDENHAIN TNC 128 (77184x-01) - Manual (Page 200)

200 Programming: Q parameters
8.8 A
d
ditional functions
In the part program, program FN 16: F-PRINT to activate the
output:
The TNC then creates the file PROT1.TXT:
MEASURING LOG OF IMPELLER CENTER OF GRAVITY
DATE: 27:11:2001
TIME: 8:56:34
NO. OF MEASURED VALUES : = 1
X1 = 149.360
Y1 = 25.509
Z1 = 37.000
HOUR Number of hours from the real-time clock
MIN Number of minutes from the real-time clock
SEC Number of seconds from the real-time clock
DAY Day from the real-time clock
MONTH Month as a number from the real-time clock
STR_MONTH Month as a string abbreviation from the real-
time clock
YEAR2 Two-digit year from the real-time clock
YEAR4 Four-digit year from the real-time clock
96 FN 16: F-PRINT TNC:\MASKE\MASKE1.A/ TNC:\PROT1.TXT
The FN 16 function overwrites already existing log files
with the same name. Use M_APPEND if you want to append
new log information to an existing log.
If you use FN 16 more than once in the program, the TNC
saves all texts in the file that you defined in the FN 16
function. The file is not output until the TNC reads the END
PGM
block, or you press the NC stop button, or you close
the file with M_CLOSE.
In the FN 16 block, program the format file and the log file
with their respective extensions.
If you enter only the file name for the path of the log file,
the TNC saves the log file in the directory in which the NC
program with the FN 16 function is located.
You can define a standard path for outputting protocol files
via the user parameters fn16DefaultPath and
fn16DefaultPathSim
(Program Test).
Keyword Function