HEIDENHAIN TNC 128 (77184x-01) User Manual
Page 22
22
11.1 Switch-on, switch-off ..... 276
11.2 Moving the machine axes ..... 278
Moving the axis using the machine axis direction buttons ..... 278
Incremental jog positioning ..... 279
Traversing with the HR 410 electronic handwheel ..... 280
11.3 Spindle speed S, feed rate F and miscellaneous functions M ..... 281
Changing the spindle speed and feed rate ..... 282
Activating feed-rate limitation ..... 283
11.4 Datum setting without a 3-D touch probe ..... 284
Workpiece presetting with axis keys ..... 285
Datum management with the preset table ..... 286
11.5 Using the 3-D touch probe ..... 291
Functions in touch probe cycles ..... 292
Selecting touch probe cycles ..... 293
Recording measured values from the touch-probe cycles ..... 294
Writing the measured values from touch probe cycles to datum tables ..... 295
Writing the measured values from touch probe cycles to the preset table ..... 296
11.6 Calibrating a 3-D touch probe ..... 297
Calibrating the effective length ..... 298
Calibrating the effective radius and compensating center offset ..... 299
Displaying calibration values ..... 302
11.7 Datum setting with a 3-D touch probe ..... 303
Datum setting in any axis ..... 303
Circle center as datum ..... 304
Center line as datum ..... 307
Measuring workpieces with a 3-D touch probe ..... 308
Using touch probe functions with mechanical probes or dial gauges ..... 310