HEIDENHAIN TNC 128 (77184x-01) - Manual (Page 342)

342 MOD functions
14.1 Selecting MOD functions
14.1 Selecting MOD functions
The MOD functions provide additional input possibilities and displays.
In addition you can enter code numbers to enable access to protected
areas. The available MOD functions depend on the selected operating
mode.
Selecting the MOD functions
Call the operating mode in which you wish to change the MOD
functions. Open the pop-up window with the MOD functions:
 Select the MOD functions: Press the MOD key. The
TNC opens a pop-up window displaying the available
MOD -functions.
Changing the settings
There are three possibilities for changing a setting, depending on the
function selected:
 Enter a numerical value directly, e.g. when determining the traverse
range limit
 Change a setting by pressing the ENT key, e.g. when setting
program input
 Change a setting via a selection window
Exiting the MOD functions
 Exit MOD functions: Press the END soft key or END key
If more than one possibility is available for a particular
setting, you can superimpose a window listing all of the
given possibilities by pressing the GOTO key. Select the
setting with the ENT key. If you don't want to change the
setting, close the window again with END.