6 optional block skip, Application, Inserting the "/" character – HEIDENHAIN TNC 128 (77184x-01) User Manual

Page 338: Erasing the "/" character, 6 optional bloc k skip 13.6 optional block skip

338

Test run and program run

13.6 Optional bloc

k skip

13.6 Optional block skip

Application

In a test run or program run, the control can skip over blocks that begin
with a slash "/":



To run or test the program without the blocks

preceded by a slash, set the soft key to ON



To run or test the program with the blocks preceded

by a slash, set the soft key to OFF

Inserting the "/" character



In the Programming mode you select the block in which the character
is to be inserted



Select the INSERT soft key

Erasing the "/" character



In the Programming mode you select the block in which the character
is to be deleted



Select the REMOVE soft key

This function does not work for TOOL DEF blocks.

After a power interruption the TNC returns to the most
recently selected setting.