HEIDENHAIN TNC 128 (77184x-01) - Manual (Page 470)

470 Touch probe cycles
20.4 F
undamentals of t
o
ol measur
ement
You can program the cycles for tool measurement in the Programming
and Editing mode of operation via the TOUCH PROBE key. The
following cycles are available:
Cycle New format Page
Calibrating the TT, Cycle 480 Page 474
Measuring the tool length, Cycle 481 Page 476
Measuring the tool radius, Cycle 482 Page 478
Measuring the tool length and radius, Cycle 483 Page 480
Measuring the tool length and radius, Cycle 483 Page 475
The measuring cycles can be used only when the central
tool file TOOL.T is active.
Before working with the measuring cycles, you must first
enter all the required data into the central tool file and call
the tool to be measured with TOOL CALL.