HEIDENHAIN TNC 128 (77184x-01) - Manual (Page 352)

352 MOD functions
14.5 Ether
n
et int
e
rf
ace
Connecting the control to the network
Overview of functions for configuring the network
 In the file manager (PGM MGT), press the Network soft key
Make sure that the person configuring your TNC is a
network specialist.
Please note that the TNC performs an automatic restart if
you change the IP address of the TNC.
Function Soft key
Establish the connection to the selected network
drive. Successful connection is indicated by a check
mark under Mount.
Separate the connection to a network drive.
Activate or deactivate the Automount function (=
automatic connection of the network drive during
control start-up). The status of the function is indicated
by a check mark under Auto in the network drive table.
Use the ping function to check whether a connection
to a particular remote station in the network is
available. The address is entered as four decimal
numbers separated by points (dotted-decimal
notation).
The TNC displays an overview window with
information on the active network connections.
Configure the access to network drives. (Selectable
only after entry of the MOD code number NET123)
Open the dialog window for editing the data of an
existing network connection. (Selectable only after
entry of the MOD code number NET123)
Configure the network address of the control.
(Selectable only after entry of the MOD code number
NET123)
Delete an existing network connection. (Selectable
only after entry of the MOD code number NET123)