HEIDENHAIN CNC Pilot 4290 Pilot - Manual (Page 85)

85
Cylindr
ical surf
ace mac
hining
Rapid traverse on cylindrical surface G110
The tool moves at rapid traverse along the shortest path to the ”end
point.”
Parameters
Z, C: End point, end angle
CY:
End point as linear value (referenced to unrolled reference
diameter G120)
X: End point (diameter)
Program either Z, C or Z, CY.
Linear movement on the cylindrical surface G111
The tool moves at the programmed feed rate on a line to the ”end
point.”
Parameters
Z, C: End point, end angle
CY:
End point as linear value (referenced to unrolled reference
diameter G120)
X: End depth (diameter value) – default: current X-position
Program either Z, C or Z, CY.