HEIDENHAIN CNC Pilot 4290 Pilot - Manual (Page 42)

42
Ov
erview:
mac
hining par
t
Tool positioning without machining Page
G0 Positioning in rapid traverse 45
G14 Approach to the tool change position 45
G701 Rapid traverse to machine coordinates 46
Simple Linear and Circular Paths Page
G1 Linear path 46
G2 Circular path 47
G3 Circular path 47
G12 Circular path 47
G13 Circular path 47
Feed rate and spindle speed Page
Gx26 Speed limit * 48
G48 Acceleration (slope) 48
G64 Discontinuous feed rate 49
Gx93 Feed rate per tooth * 49
G94 Feed per minute 49
Gx95 Feed in revolutions 49
Gx96 Constant surface speed 49
Gx97 Spindle speed 49
Cutter radius compensation (TRC/MCRC) Page
G40 Switch off TRC/MCRC 50
G41 TRC/MCRC left 50
G42 TRC/MCRC right 50
* ”x” = number of the spindle (0...3)
G Functions for Machining
The following functions must be preceded with the section
code MACHINING.
For contour-based turning cycles define the reference to the
contour description in ”NS, NE.” You can determine this
reference as follows:
Activate contour display (menu item ”Graphic”).
Place the cursor on the ”NS/NE” field and press the
Continue key.
Select the desired contour element with the left/right arrow
key.
The up/down arrow keys can be used to switch between
several contours (also end face contours, etc.)
Transfer the block number of the contour element (”Enter”
key).
If you activate the up/down arrow keys, the
CNC PILOT also considers contours that are not
displayed on the screen.