HEIDENHAIN CNC Pilot 4290 Pilot - Manual (Page 49)

49
Feed rate per revolution Gx95
G95: Spindle; Gx95: Spindle x (x: 1...3)
G95/Gx95 defines the feed rate as a function of
drive.
Parameters
F:
Feed rate in mm/revolution or inch/revolution
Feed rate constant G94 (minute feed)
G94 defines the feed rate as a function of drive.
Parameters
F:
Feed rate per minute (in mm/min or inch/min)
Feed rate per tooth spindle x Gx93
Gx93 (x: spindle 1...3) defines the feed rate drive-dependent,
depending on the number of teeth of the cutter.
Parameters
F:
Feed rate per tooth (mm/tooth or inch/tooth)
The actual value display shows the feed rate in mm/rev.
Speed Gx97
G97: spindle; Gx97: spindle x (x: 1...3)
G97/Gx97 defines a constant spindle speed.
Parameters
S:
Speed (in revolutions per minute)
Constant cutting speed Gx96
G96: spindle; Gx96: spindle x (x: 1...3)
G96/Gx96 defines a constant cutting speed. The
spindle speed is dependent on the X position of the
tool tip or on the tool diameter (with driven tools).
Parameters
S:
Cutting velocity (in m/min or ft/min)
F
e
ed r
a
te
and spindle speed
Interrupted (intermittent) feed G64
G64 interrupts the programmed feed for a short period of time.
■ For switch-on, program G64 with E and F.
■ For switch-off, program G64 without parameters.
Parameters
E:
Duration of pause (range: 0.01 s < E < 99.99 s)
F: Duration of feed rate (range: 0.01 s < E < 99.99 s)