HEIDENHAIN CNC Pilot 4290 Pilot - Manual (Page 83)

83
F
ront/end f
ace mac
hining
Rapid traverse on end face G100
The tool moves at rapid traverse along the shortest path to the ”end
point.”
Parameters
X, C: End point, end angle
XK,YK: End point
Z:
end points
Program either X, C or XK, YK.
Linear segment on end face G101
The tool moves at the programmed feed rate on a line to the ”end
point.”
Parameters
X, C: End point, end angle
XK,YK: End point
Z:
End depth – default: current Z position
Program either X, C or XK, YK.