HEIDENHAIN CNC Pilot 4290 Pilot - Manual (Page 40)

40
Figur
es on the
lat
e
ra
l surf
ace
Linear pattern on lateral surface G411 Geo
G411 defines a linear pattern on the lateral surface. G411 is effective for
the bore hole/figure defined in the following block (G310..315, 317).
Parameters
Q:
Number of figures
Z, C: Starting point, starting angle of pattern
K, W: End point, end angle of pattern
Ki:
Distance between the figures (in Z-direction)
Wi: Angular distance between the figures
A: Angle of pattern length axis (reference: Z axis)
R: Total length of pattern
Ri: Distance between two figures (pattern distance)
If you program Q, Z and C, the bore holes/figures will be
ordered in a regular manner along the circumference.