HEIDENHAIN CNC Pilot 4290 Pilot - Manual (Page 17)

17
Undercut DIN 509 E (H=0, 5)
Undercut DIN 509 F (H=6)
Undercut DIN 509 E (H=0, 5)
Parameters
I:
Depth of undercut (radius)
K: Width of undercut
R: Undercut radius (in both corners of the undercut)
W: Undercut angle
If you do not enter any parameters the CNC PILOT calculates
the values from the diameter (see User's Manual, section
“Undercut Parameters DIN 509 E”).
Undercut DIN 509 F (H=6)
Parameters
I:
Depth of undercut (radius)
K: Width of undercut
R: Undercut radius (in both corners of the undercut)
P: Transverse depth
W: Undercut angle
A: Transverse angle
If you do not enter any parameters the CNC PILOT calculates
the values from the diameter (see User's Manual, section
“Undercut Parameters DIN 509 F”).
Continued
F
o
rm
elements
fo
r cont
our descr
iption