HEIDENHAIN CNC Pilot 4290 Pilot - Manual (Page 45)

45
Tool change point G14
The slide moves in rapid traverse to the tool change position. In setup
mode, define permanent coordinates for the tool change.
Parameters
Q:
Sequence – default: 0
0:
Diagonal path of traverse
1: First in X axis, then in Z
2: First in Z axis, then in X
3: X axis only
4: Z direction only
Rapid traverse G0
The tool moves at rapid traverse along the shortest path to the ”target
point.”
Parameters
X, Z: Diameter, length to target point (X diameter)
T
ool positioning
without mac
hining