HEIDENHAIN PT 855 for Turning - Manual (Page 81)

II - 7 Specifications
POSITIP 855 Technical Information 83
Specifications
POSITIP
Axes Up to 4 axes from X, Y, Z, A, B, C, U, V, W
Display Flat luminescent screen:
position values, dialogs, entries, graphics
Status display Operating mode, REF, inches, scaling factor
Graphic positioning aid with distance-to-go display
Oversize, feed rate, tool number
Diameter display, sum display Z
S
and/or X
S
Position encoders Incremental HEIDENHAIN linear encoders with sinusoidal output signals
Display step Linear axes: 5 µm, 1 µm or finer (to 0.02 µm)
Functions • REF reference mark evaluation
•
Distance-to-go mode, nominal position absolute or incremental
• Scaling factor
• Linear machine error compensation
• HELP::::: on-screen operating instructions
• INFO::::: pocket calculator, stopwatch, taper calculator
• One datum point and table for up to 99 tools
• Oversizes
• Freezing the displayed tool position during retraction (note/set)
Programming Memory for up to 20 programs
and a total of 2000 program blocks
Up to 1000 blocks per program
Subprogramming; Teach-in (actual-position capture)
Multipass cycle in the program
Data interface RS-232-C/V.24; for output of programs, measured values and parameters
Baud rate: 110 / 150 / 300 / 600 / 1200 / 2400 / 4800 / 9600 / 19200 / 38400
Accessories • Floppy disk unit for external storage of programs
• Tilting base
Switching outputs • 8 digital outputs (24 V), assigned to the axes with parameters
• 1 “POSITIP is ready for operation” digital output
Switching inputs • 1 input for each axis for zero reset
• 2 inputs for measured value output (pulse or contact)
Power source Switching power supply 100 V to 240 V (–15% to +10%), 48 to 62 Hz
Power consumption 24 W
Operating temperature 0° to 45° C (32° to 113° F)
Storage temperature –30° to 70° C (–22° to 158° F)
Weight 4.8 kg
II - 7