HEIDENHAIN PT 855 for Turning - Manual (Page 70)

II - 3 Encoders and Measured Value Display
72 Technical Information POSITIP 855
Setting the measured value display
Designation of the coordinate axes: P49.
∗∗∗∗∗
Axis is coordinate axis A: P 49.* = 65
Axis is coordinate axis B: P 49.* = 66
Axis is coordinate axis C: P 49.* = 67
Axis is coordinate axis X: P 49.* = 85
Axis is coordinate axis Y: P 49.* = 86
Axis is coordinate axis Z: P 49.* = 87
Axis is coordinate axis U: P 49.* = 88
Axis is coordinate axis V: P 49.* = 89
Axis is coordinate axis W: P 49.* = 90
Unit of measurement: P 1 (user parameter)
Display dimensions in millimeters (mm): P 1 = 0
Display dimensions in inches (inch): P 1 = 1
In the diameter display mode, the symbol for the diameter (Ø) appears next
to the display value, and the display value doubles.
Radius/diameter display: P 3.* (user parameter)
Display position values as radius: P 3.* = 0
Display position values as diameter: P 3.* = 1
In the separate value display mode, POSITIP displays the positions of the
saddle and top slide separately. In the sum display mode, the position val-
ues of the two axes are added together.
Separate value/sum display: P 5.* (user parameter)
Separate value display mode: P 5.* = 0
Sum display mode: P 5.* = 1