HEIDENHAIN PT 855 for Turning - Manual (Page 60)

II - 2 Operating Parameters
62 Technical Information POSITIP 855
Operating Parameters
Operating parameters adapt the POSITIP to the machine. They are
identified with the letter P, a three-digit number and a name.
Axis-specific operating parameters
Some parameters require separate entries for each axis. Such pa-
rameters are identified in the following descriptions with a star (
∗∗∗∗∗
).
Example: Operating parameter for the counting direction: P30.
∗∗∗∗∗
For this parameter you enter the counting direction separately for
each axis in parameters P30.1, P30.2, P30.3 and P30.4.
Factory settings
The factory settings for the operating parameters in the overview
on the next pages are set in
bold italics.
Numerical input, dialog input
The current setting of an operating parameter is shown in plain lan-
guage under the parameter designation in the on-screen operating
parameter list. In addition, each parameter setting has a number in
the input line at the top. These numbers are transferred when you
read out the operating parameters over the data interface.
To access the operating parameters
➤ ➤ ➤ ➤ ➤ Press MOD.
➤
➤ ➤ ➤ ➤ Go to the soft key row containing Code Number ( soft key
with the key symbol)
➤ ➤ ➤ ➤ ➤ Press the soft key Code Number
➤ ➤ ➤ ➤ ➤ Enter the code number 95148.
➤
➤ ➤ ➤ ➤ Confirm your entry by pressing the ENT key
➤
➤ ➤ ➤ ➤ Display the operating parameters one after the other with the
vertical arrow keys; or
➤ ➤ ➤ ➤ ➤ Go directly to an operating parameter:
Press GOTO, enter the parameter number and confirm with
ENT.
To change parameter settings
Operating parameter settings can be changed by selecting the new
setting or entering a numerical value.
➤
➤ ➤ ➤ ➤ Select a new setting: Press the horizontal arrow key.
or
➤ ➤ ➤ ➤ ➤ Enter a numerical value directly and confirm your entry with
ENT.
The horizontal arrow key has no function with parameters which
only allow direct numerical entry.
II - 2
Fig. 35: Example of operating parameters