HEIDENHAIN PT 855 for Turning - Manual (Page 62)

II - 2 Operating Parameters
64 Technical Information POSITIP 855
User parameters
The machine manufacturer has defined certain operating param-
eters as user parameters. You can change the settings of user
parameters without having to enter a code number (see Operating
Instructions section, Chapter I - 6).
Position of user parameters in the menu
In operating parameters P100 to P120, the machine manufacturer
defines how the user parameters are arranged in the soft key
displays.
Field 15 is reserved for the soft key Code Number
If a parameter is assigned to field number 0, it will not appear in
the user parameter menu.
Operating User parameter Standard
parameter designation * field
✍ ✍ ✍ ✍ ✍
P 100 mm / inch (P 1) 4 ........
P 101.1 Radius / diameter 1 (P 3.1) 1
P 101.3 Radius / diameter 3 (P 3.3) 0 ........
P 102.1 Separate / sum 1 (P 5.1) 0 ........
P 102.3 Separate / sum 3 (P 5.3) 2 ........
P 104 Scaling factor On / Off (P 11) 8 ........
P 105.1 Scaling factor 1 (P 12.1) 6 ........
P 105.3 Scaling factor 3 (P 12.3) 7 ........
P 106 Oversize On / Off (P 14) 13 ........
P 107.1 Oversize 1 (P 15.1) 11 ........
P 107.3 Oversize 3 (P 15.3) 12 ........
P 112 RS-232 baud rate (P 50) 0 ........
P 113 RS-232 blank lines (P 51) 0 ........
P 120 Tool table 5 ........
* The corresponding operating parameters are indicated in
parentheses.
11 6 1
12 7 2
13 8 3
14 9 4
15 10 5
Fig. 37: Field numbering for user parameters