HEIDENHAIN PT 855 for Turning - Manual (Page 36)

I - 3 Programming POSITIP
POSITIP 855 Operating Instructions 37
Multipass cycle
Go to the first soft key row.
/
Select the coordinate axis (X axis).
N o m i n a l p o s i t i o n v a l u e ?
ENT 5
Select the coordinate axis (Z
S
axis).
N o m i n a l p o s i t i o n v a l u e ?
ENT
3 0
Program blocks
0 BEGIN PGM 20 MM Start of program, program number and unit of measurement
1 X+80.000 Pre-position tool in the X axis
2 Z+20.000 Pre-position tool in the Z axis
3 X+50.000 Approach the workpiece (X axis)
4 Z+0.000 Approach the workpiece (Z axis)
5 CYCL 3.0 MULTIPASS Coordinates for a Multipass cycle follow this block
6 X+10.000 X coordinate of the shoulder
7 Z–30.000 Z coordinate of the shoulder
8 X+80.000 Retract (X axis)
9 Z+20.000 Retract (Z axis)
10 END PGM 20 MM End of program, program number and unit of measurement
The cycle is performed in the operating mode EXECUTE PROGRAM
(see Chapter I - 4) by traversing to display value zero with any
number of infeeds.
Enter the nominal position value (X = 5 mm). Confirm entry.
Enter the nominal position value (Z
S
= –30 mm). Confirm entry.