Enterasys Networks Enterasys Matrix 6H303-48 - Manual (Page 87)

Memory Locations and Replacement Procedures
Matrix DFE-Gold Series Installation Guide B-7
DIMM Replacement Procedure
The DIMM is considered a field replaceable unit on both the 4G4202‐72 and 4G4282‐49.
Removing the DIMM
To remove the existing DIMM, proceed as follows:
1. Locate the DIMM connector on the main PC board. Refer to Figure B‐2 .
2. Push the connector arms away from the DIMM, as shown in Figure B‐7 , enough to
release the DIMM from the connector contacts.
Figure B-7 Removing Existing DIMM from 4G4202-72 or 4G4282-49
3. Pull the DIMM straight up and remove it from the connector contacts.
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
1 Connector arms 2 DIMM 3 Connector contacts
В
Б
А
А