Removing the coverplate, Installing the network expansion module, Removing the coverplate -3 – Enterasys Networks Enterasys Matrix 6H303-48 User Manual
Page 35
Installing Optional Network Expansion Modules
Matrix DFE-Gold Series Installation Guide 3-3
Removing the Coverplate
Refer to
and proceed as follows:
1.
Attach the antistatic wrist strap (refer to the instructions on the antistatic wrist strap
package).
2.
Place the DFE‐Gold module on an antistatic pad on a sturdy flat surface.
Figure 3-1 Removing the Coverplate
3.
Remove and save the two coverplate screws fastening the coverplate to the DFE‐Gold
module front panel.
4.
Remove and save the screw fastening the coverplate to the standoff on the main
board.
5.
Lift and remove the coverplate from the module and save for possible future use.
Installing the Network Expansion Module
Refer to
and proceed as follows:
1.
Carefully align the two network expansion module connectors with the main board
connectors. Then press straight down over the two network expansion module
connectors, applying pressure until they are properly seated.
1 Main board
4 DFE Module front panel
2 Front panel coverplate screws (2)
5 Standoff screw
3 Coverplate
6 Standoff
COM
OFFLINE/ RESET
MGMT
CPU
1
2
3
GR
OUP
SELECT
1X
11X
13X
4
12X
14X
23X
24X
25X
26X
35X
36X
37X
38X
47X
48X
G R
O U
P
1
G R
O U
P
2
G R
O U
P
3
G R
O U
P
4
GR
OUP
1
2
3
4
5
6
7
8
9
10
11
12
4G
42
82
-4
9
Gb ENET
DFE
Б
Г
А
В
Д
Е