Enterasys Networks Enterasys Matrix 6H303-48 - Manual (Page 38)

Installing an Optional Mini-GBIC
3-6 Installation
Installation
To install a Mini‐GBIC with an MT‐RJ connection, refer to Figure 3‐3 . For an LC
connection, refer to Figure 3‐4 . For an RJ45 connection, refer to Figure 3‐5 . Then proceed
as described below.
1. Hold the Mini‐GBIC with its top side facing up and its 7‐pin edge connector facing the
port slot.
2. Carefully align the Mini‐GBIC with the port slot.
3. Push the Mini‐GBIC into the port slot until the Mini‐GBIC “clicks” and locks into
place.
Figure 3-3 Mini-GBIC with MT-RJ Connector
Note: If the Mini-GBIC is one with an RJ45 connector such as an MGBIC-02 ( Figure 3-5 ),
the installation procedure is the same as described below. However, the Mini-GBIC has a
wire handle to release it.
1 Mini-GBIC (MGBIC-MT01) 4 Port slot
2 Mini-GBIC , top side 5 Mini-GBIC , protective dust cover
3 7-Pin edge connector (insertion side) 6 Release tab
1
2
3
4
5
6
1
2
3
4
5
6
7G-6MGBIC-A
Г
В
Е
А
Б
Д