Enterasys Networks Enterasys Matrix 6H303-48 - Manual (Page 82)

Setting the Mode Switches
B-2 Mode Switch Bank Settings and Optional Installations
Figure B‐1 through Figure B‐3 show the location of the mode switches and the switch
settings for normal operation. These switches are set at the factory to the off position and
rarely need to be changed.
Switch definitions and positions are as follows:
• Switches 1 through 6 – For Enterasys Networks use only.
• Switch 7 – Clear Persistent Data. Changing the position of this switch clears Persistent
Data on the next power‐up of the module. (Persistent Data refers to data stored in
non‐volative memory, or NVRAM.) All user‐entered parameters, such as the IP
address and module names, are reset to the factory default settings. Once the module
resets, you can either use the factory default settings or reenter your own parameters.
• Switch 8 – Clear Admin Password. Changing the position of this switch clears the
admin password, and restores the factory default password on the next power‐up of
the module. Once the module resets, you can either use the factory default settings or
reenter your own password.
Figure B-1 Mode Switch Location on 4G4202-72 and 4G4282-49
Note: Do not change the position of Switch 8 unless it is necessary to reset the admin
password to its factory default setting.
1 Mode switch pack is in the same location on both DFE-Gold modules (4G4202-72 shown)
1 2 3 4 5 6 7 8
ON
À
COM
OFFLINE/ RESET GR OUP 3
GR OUP 1
GR OUP 2
CPU MGMT
GR OUP
1
2 3
GR OUP
SELECT
1X
6X 7X
12X 13X
18X 19X
24X
4G 42 82 -4 9
Gb ENET