Enterasys Networks Enterasys Matrix 6H303-48 - Manual (Page 57)

Connecting to COM Port for Local Management
Matrix DFE-Gold Series Installation Guide 3-25
Figure 3-15 Connecting an IBM PC or Compatible Device
Connecting to a VT Series Terminal
To connect a VT Series terminal to an Enterasys Networks DFE‐Gold module COM port
(
Figure 3‐16 ), use a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25
female adapter, and proceed as follows:
1. Connect the RJ45 connector at one end of the UTP straight‐through cable to the COM
port on the Enterasys Networks module.
2. Plug the RJ45 connector at the other end of the UTP straight‐through cable into the
RJ45‐to‐DB25 female adapter.
3. Connect the RJ45‐to‐DB25 adapter to the port labeled COMM on the VT terminal.
4. Turn on the terminal and access the Setup Directory. Set the following parameters on
your terminal:
1 UTP straight-through cable with RJ45 connectors 3 RJ45-to-DB9 PC adapter
2 RJ45 COM port 4 IBM PC or compatible device
COM
OFFLINE/
RESET
GROUP 3 GROUP 1 GROUP 2
CPU
MGMT
1X
6X
4G4202-72
Gb ENET
В Г А
Б
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit