Dram simm replacement procedure, Figure b‐3, Removing the dram simm – Enterasys Networks Enterasys Matrix 6H303-48 User Manual
Page 84: А б в
Memory Locations and Replacement Procedures
B-4 Mode Switch Bank Settings and Optional Installations
Figure B-3 Memory Module Locations on the 4G4282-49
DRAM SIMM Replacement Procedure
Removing the DRAM SIMM
To remove the DRAM SIMM, proceed as follows:
1.
If an network expansion module is installed on the main board of the 4G4282‐49, refer
to
on page B‐5 and proceed to step 1a. Otherwise proceed to step 2.
a.
Remove and save the three screws attaching the network expansion module to
the front panel and to the standoff on the main PC board.
b. Lift the network expansion module straight up and off the two module
connectors on the main PC board.
1 DRAM SIMM
2 DIMM
3 Main PC board
А Б
В
COM
OFFLINE/ RESET
MGMT
CPU
1
2
3
GR
OUP
SELECT
1X
11X
13X
4
12X
14X
23X
24X
25X
26X
35X
36X
37X
38X
47X
48X
G R
O U
P
1
G R
O U
P
2
G R
O U
P
3
G R
O U
P
4
GR
OUP
1
2
3
4
5
6
7
8
9
10
11
12
4G
42
82
-4
9
Gb ENET
DFE
1
2
3
4
5
6
1
2
3
4
5
6
7G-6MGBIC-A
Note: To replace the DRAM SIMM on the 4G4282-49, you must remove the network
expansion module if one is installed.
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
Note: Prior to removing the DRAM SIMM from a 4G4282-49, you must remove the
network expansion module to gain access to the DIMM memory and connector.