Enterasys Networks Enterasys Matrix 6H303-48 - Manual (Page 33)

Matrix DFE-Gold Series Installation Guide 3-1
3
Installation
This chapter provides the instructions to install the 4G4202‐72 and 4G4282‐49 DFE‐Gold
modules, and an optional network expansion module.
A Phillips screwdriver is needed to install the optional network expansion module into
the 4G4282‐49. Follow the order of the sections listed below to correctly install the
modules.
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.
Important Notice
Read the Release Notes shipped with the DFE-Gold module to check for any exceptions to the
supported features and operation documented in this guide.
Note: Unless otherwise noted, the installation instructions apply to both DFE-Gold
modules.
For information about... Refer to page...
Unpacking the DFE-Gold Module 3‐2
Installing Optional Network Expansion Modules 3‐2
Installing an Optional Mini-GBIC 3‐5
Module Placement and Rules 3‐9
Installing the DFE Module into a Chassis 3-11
Connecting to the Network 3-15
Connecting to COM Port for Local Management 3-23