Installing the network expansion module -4 – Enterasys Networks Enterasys Matrix 6H303-48 User Manual
Page 36
Installing Optional Network Expansion Modules
3-4 Installation
Figure 3-2 Installing the Network Expansion Module
2.
Use the two saved coverplate screws to fasten the network expansion module to the
DFE‐Gold module front panel. Do not tighten the two coverplate screws at this time.
3.
Use the saved screw from the
standoff to fasten the network expansion module to the
standoff.
Tighten the screw.
4.
Tighten the two front‐panel coverplate screws.
5.
This completes the network expansion module installation. To install Mini‐GBICs into
the network expansion module, proceed to “
Installing an Optional Mini‐GBIC
page 3‐5 for the Mini‐GBIC installation instructions. Otherwise, proceed to “
” on page 3‐9 to install the DFE module into the chassis.
1 Screw (1)
4 Optional expansion module
7 Main board connectors
2 Main bo\ard
5 DFE-Gold module
front panel
8 Coverplate screws (2)
3 Standoff
6 Expansion module connectors
COM
OFFLINE/ RESET
MGMT
CPU
1
2
3
GR
OUP
SELECT
1X
11X
13X
4
12X
14X
23X
24X
25X
26X
35X
36X
37X
38X
47X
48X
G R
O U
P
1
G R
O U
P
2
G R
O U
P
3
G R
O U
P
4
GR
OUP
1
2
3
4
5
6
7
8
9
10
11
12
4G
42
82
-4
9
Gb ENET
DFE
Á
1
2
3
4
5
6
1
2
3
4
5
6
7G-6MGBIC-A
З
Г
Д
Е
Ж
А
В