Enterasys Networks Enterasys Matrix 6H303-48 - Manual (Page 47)

Connecting to the Network
Matrix DFE-Gold Series Installation Guide 3-15
Figure 3-7 Installing Module into N1, N3, or N5 Chassis (only N3 shown)
Connecting to the Network
This section provides the procedures for connecting unshielded twisted pair (UTP)
segments from the network or other devices to the 4G4282‐49 and 4G4202‐72
(“
Connecting UTP Cables ” on page 3‐16). For connections to Mini‐GBIC ports on the
7G‐6MGBIC or 7G‐6MGBIC‐A, refer to “ Connecting Fiber‐Optic Cables to Mini‐GBICs ”
on page 3‐20.
1 Card guides 5 Upper locking tab (shown in closed position)
2 Slot 1 (Top slot is slot 3.) 6 Lower locking tab (shown in closed position)
3 Module card 7 FTM2 backplane connectors
4 Metal back panel
FAN
STATUS
7C203-1
REDUNDANCY
PWR
100-125V~12.0A
200-240V~6.0A
50/60 Hz
0
7C203-1
REDUNDANCY
PWR
100-125V~12.0A
200-240V~6.0A
50/60 Hz
0
COM
OFFLINE/ RESET
GR OUP 3
GR OUP 1
GR OUP 2 CPU MGMT
GR OUP
123 GR OUP SELECT
1X 6X 7X 12X 13X 18X 19X 24X
7G4202-72 Gb ENET
Б
Ж
Д
В
А Г
Е
Note: If the DFE-Gold module is being installed in a network using Link Aggregation, there
are rules concerning network cables and port configurations that must be followed for Link
Aggregation to operate properly. Before connecting the cables, refer to the
Matrix DFE-Gold Series Configuration Guide for the configuration information. For details
on how to obtain manuals, refer to the
“ Related Documents ” on page xiv .