HEIDENHAIN ND 1200T - Manual (Page 86)

Chapter 3 Setup
3-34
Nominal (Standard)
Actual (Measured)
Select the desired axis and enter the nominal and actual end points
of each segment into the SLEC Standard and Observed data fields
as shown below. A maximum of 30 segments (0-29) can be en-
tered (7 are shown in this example).
Enter the offset from the Machine zero to the standard’s datum
for the current axis into the MZ Offset data field.
Press the ON softkey to use SLEC compensation for the selected
axis.
When all the data are entered for all axes, press the left cursor
arrow or Finish button to return to the Setup menu.