HEIDENHAIN ND 1200T - Manual (Page 62)

Chapter 3 Setup
3-10
DD Disp Res
Defines the measurement resolution displayed on the TC200 for
angular information in decimal degree format. Any resolution at
or below the resolution of the encoder is a valid entry for this
field. Do not enter a resolution higher than the encoder resolu-
tion. Consult the encoder product information to determine its
resolution. This data entry field requires the supervisor password
prior to access.
NOTE NOTE NOTE NOTE NOTE
When inputting resolution remember that .0001mm is a higher
When inputting resolution remember that .0001mm is a higher When inputting resolution remember that .0001mm is a higher When inputting resolution remember that .0001mm is a higher When inputting resolution remember that .0001mm is a higher
resolution than .0002mm. Therefore, any entry less than
resolution than .0002mm. Therefore, any entry less than resolution than .0002mm. Therefore, any entry less than resolution than .0002mm. Therefore, any entry less than resolution than .0002mm. Therefore, any entry less than
.0002mm exceeds the resolution of an encoder with .0002mm
.0002mm exceeds the resolution of an encoder with .0002mm .0002mm exceeds the resolution of an encoder with .0002mm .0002mm exceeds the resolution of an encoder with .0002mm .0002mm exceeds the resolution of an encoder with .0002mm
resolution.
resolution. resolution. resolution. resolution.
Startup Linear
Defines the default display of linear measurements. Options for
this field include MM (metric/millimeters), Inch (English/decimal
inches), and Last. The Last option will retain the last selection
made via the mm mode selection key through power cycles. For
example, if inches was the last unit selected with the mm key prior
to shutdown, the TC200 will startup in inches for its next use.
Selections for this field are made using softkeys.