HEIDENHAIN ND 1200T User Manual

Page 35

Tool-Chek

TC200

2-9

Step 4
Enter the value for Nominal X. Nominal X is the diameter or radius
of the setting gage. Press enter.

NOTE

NOTE
The TC200 displays either ‘Dia’ or ‘Rad’ next to input field for

The TC200 displays either ‘Dia’ or ‘Rad’ next to input field for

The TC200 displays either ‘Dia’ or ‘Rad’ next to input field for
Nominal X to indicate whether the value is a diameter or radius.

Nominal X to indicate whether the value is a diameter or radius.

Nominal X to indicate whether the value is a diameter or radius.
This indication can be changed by pressing the Diameter/Radius

This indication can be changed by pressing the Diameter/Radius

This indication can be changed by pressing the Diameter/Radius
mode selection key

mode selection key

mode selection key.....

NOTE

NOTE
When the user changes the mode from diameter or radius the

When the user changes the mode from diameter or radius the

When the user changes the mode from diameter or radius the
value entered remains the same. Be certain to adjust the value

value entered remains the same. Be certain to adjust the value

value entered remains the same. Be certain to adjust the value
entered to obtain accurate presets.

entered to obtain accurate presets.

NOTE

NOTE
Be certain to use the correct units of measurement to avoid

Be certain to use the correct units of measurement to avoid

Be certain to use the correct units of measurement to avoid
errors. The units of measure are displayed at the top right corner

errors. The units of measure are displayed at the top right corner

errors. The units of measure are displayed at the top right corner
of the screen. T

of the screen. T

of the screen. To change the units of measure press the mm/

o change the units of measure press the mm/

inches mode selection key

inches mode selection key.....

Step 5
Enter the value for Nominal Z. Nominal Z via the distance from
the datum to the tip of the setting gage. Press enter.