Nominal z – HEIDENHAIN ND 1200T User Manual

Page 39

Tool-Chek

TC200

2-13

NOTE

NOTE
The TC200 displays either ‘Dia’ or ‘Rad’ next to input field for

The TC200 displays either ‘Dia’ or ‘Rad’ next to input field for

The TC200 displays either ‘Dia’ or ‘Rad’ next to input field for
Nominal X to indicate whether the value is a diameter or radius.

Nominal X to indicate whether the value is a diameter or radius.

Nominal X to indicate whether the value is a diameter or radius.
This indication can be changed by pressing the Diameter/Radius

This indication can be changed by pressing the Diameter/Radius

This indication can be changed by pressing the Diameter/Radius
mode selection key

mode selection key

mode selection key.....

NOTE

NOTE
Be certain to use the correct units of measurement to avoid

Be certain to use the correct units of measurement to avoid

Be certain to use the correct units of measurement to avoid
errors. The units of measure are displayed at the top right corner

errors. The units of measure are displayed at the top right corner

errors. The units of measure are displayed at the top right corner
of the screen. T

of the screen. T

of the screen. To change the units of measure press the mm/

o change the units of measure press the mm/

inches mode selection key

inches mode selection key.....
Step 5
Nominal Z is the length of the tool. Use the numeric keypad to
enter a value for nominal Z and press enter.

Step 6
Enter the name of the setting gage to be used with this tool. The
setting gage name may be entered with the numeric keypad or by
pressing the list softkey. When using the list softkey, use the up or
down arrow keys to scroll through the list. Highlight the setting
gage to be used and press enter. If the setting gage has not been
entered the user will be unable to save the tool data.

Step 7
The TC200 allows the user to store the location of tools in the
location field. Location refers to the physical storage location of
the tool and not the position of the tool (POT) in the automated
tool changer. Entries in this field are optional. Use the numerical
keypad to enter the tool location and press enter. To continue
without entering a location simply press enter.