HEIDENHAIN ND 1200T - Manual (Page 27)

Chapter 2
Operation
This chapter demonstrates the operation of the Tool-Chek 200.
This demonstration is provided to allow experienced operators to
start using the TC200 immediately. The demonstration will be
most helpful if you perform the indicated steps on your TC200
while reading this material.
NOTE NOTE NOTE NOTE NOTE
Illustrations are included in this manual to indicate the basic
Illustrations are included in this manual to indicate the basic Illustrations are included in this manual to indicate the basic Illustrations are included in this manual to indicate the basic Illustrations are included in this manual to indicate the basic
types or displays found while operating the TC200. Specific
types or displays found while operating the TC200. Specific types or displays found while operating the TC200. Specific types or displays found while operating the TC200. Specific types or displays found while operating the TC200. Specific
data (i.e. measurements) will vary according to user selections.
data (i.e. measurements) will vary according to user selections. data (i.e. measurements) will vary according to user selections. data (i.e. measurements) will vary according to user selections. data (i.e. measurements) will vary according to user selections.
It is not necessary to match actual measurements to those
It is not necessary to match actual measurements to those It is not necessary to match actual measurements to those It is not necessary to match actual measurements to those It is not necessary to match actual measurements to those
presented here.
presented here. presented here. presented here. presented here.
The demonstration will include:
• Getting ready to operate the TC200
• Applying power
• Initial system settings
• Measuring and storing a setting gage
• Measuring and entering a tool
• Creating a tool sequence
• Measuring a circle
• Measuring an angle
The contents of LCD screens used in this demonstration will re-
flect a system using X and Z axis encoders configured with factory
default settings.
Getting ready to
operate the TC200
This demonstration assumes a basic familiarity with the process of
measuring features, TC200 controls and indicators, and the types
of information presented on LCD screens.
2-1