HEIDENHAIN ND 1200T - Manual (Page 54)

Chapter 3 Setup
3-2
The Setup Menu
All operating parameters of the TC200 can be configured using
functions in the Setup menu. These parameters include:
• Language shown on the LCD display
• Display format of tool data
• Encoder configuration
• Print configuration for reports and labels
• Ports configuration for serial and parallel
• Supervisor password
• Squareness angle
• LEC (Linear Error Correction)
• SLEC (Segmented Linear Error Correction) configuration
• Scale factor
• Misc (Miscellaneous) parameters
• Clock date and time settings
Setup configurations are retained by the TC200 until changed by
the user.
Accessing the
Setup menu
The Setup menu is accessed by pressing the Menu key and then
pressing the Setup softkey. Setup menu procedures are divided
into user level procedures and supervisor level procedures. Super-
visor level procedures require the input of the supervisor pass-
word in the Supervisor setup screen. If the supervisor password
has not been entered, all supervisor level procedures are inacces-
sible. The supervisor password is not retained through power
cycles; it must be re-entered each time the unit is turned off and
on.
The Setup menu contents are displayed on the left side of the
screen with the About setup screen highlighted.