HEIDENHAIN ND 1200T - Manual (Page 29)

Tool-Chek ® TC200
2-3
CAUTION CAUTION CAUTION CAUTION CAUTION
Never connect electrical cables to the system when the power is
Never connect electrical cables to the system when the power is Never connect electrical cables to the system when the power is Never connect electrical cables to the system when the power is Never connect electrical cables to the system when the power is
on. Optical edge detector cables may be connected or
on. Optical edge detector cables may be connected or on. Optical edge detector cables may be connected or on. Optical edge detector cables may be connected or on. Optical edge detector cables may be connected or
disconnected with the power on.
disconnected with the power on. disconnected with the power on. disconnected with the power on. disconnected with the power on.
Applying power
To apply power, press the power switch located at the back of the
enclosure to ON (1). The system will initialize and display the power-
up screen.
Press any key on the front panel to complete the system initializa-
tion. The DRO screen will be displayed showing the current posi-
tions of encoders on each axis.
NOTE NOTE NOTE NOTE NOTE
If the encoders used with your system include reference marks,
If the encoders used with your system include reference marks, If the encoders used with your system include reference marks, If the encoders used with your system include reference marks, If the encoders used with your system include reference marks,
you may be instructed to cross the reference marks on each axis
you may be instructed to cross the reference marks on each axis you may be instructed to cross the reference marks on each axis you may be instructed to cross the reference marks on each axis you may be instructed to cross the reference marks on each axis
before the DRO screen is displayed.
before the DRO screen is displayed. before the DRO screen is displayed. before the DRO screen is displayed. before the DRO screen is displayed.